id: 3.2-airport-properties title: 3.2 Airport Properties meta: Learn how to change airport properties within the Scenery Editor of Infinite Flight. order: 2 #
3.2 Airport Properties #
3.2.1 #
To edit airport properties the below steps must{.red} be followed:
Step 1
: Tap “File > Airport Properties” (1) from the management buttons on the left of the screen
Step 2
: The airport properties will appear on the right hand side of the screen (2)
Step 3
: All are adjusted by tapping the property, except for “Frequencies” (see 3.2.3 below) and then entering the new value/name and tapping “OK”
Step 4
: Some of the properties may already be populated, Editors must{.red} ensure that these are correct and fill in any properties that are missing
3.2.2 #
| Airport Property | Purpose |
|---|---|
| ICAO | Four letter ICAO code (e.g. KSFO or EGLL) |
| Elevation | Elevation of the airport |
| Name | Name of the airport |
| Spoken Name | Name of the airport that will be spoken in-app |
| City | City that the airport is located in (or nearest to) |
| Country | Country that the airport is located in |
| State | State or equivalent (such as county) that the airport is located in |
| IATA Code | Three letter IATA code (e.g. SFO or LHR) |
| FAA Code | Three to five letter alphanumeric code for airports in the USA only (usually similar to the IATA code) |
| Airport Class | Class of airport (from Alpha to Echo) |
| Latitude | Latitude of the airport (this should not{.red} be changed) |
| Longitude | Longitude of the airport (this should not{.red} be changed) |
| Frequencies | The frequencies of the airport |
| Taxiway Routes Available | When selected, orange tick is displayed (must{.red} be selected for ATC taxiway network to be available to controllers and pilots) |
| Jet Bridges Available | When selected, orange tick is displayed (must{.red} be selected for animated jet bridges to be available to pilots but only once jet bridges have been added and are usable - see 10.4.1 below) |
3.2.3 #
To add/delete or edit frequencies, the below steps must{.red} be followed:
Step 1
: Tap the “+” symbol next to “Frequencies” (1)
Step 2
: All frequencies currently listed for that airport will appear beneath. Tap the “+” symbol to the left of a frequency to open its properties (2)
Step 3
: Frequency Type, Name, Frequency and Spoken Name can all be changed in the same way as other airport properties (see 3.2.1 above)
Step 4
: Tap the “-” symbol to the left of the same frequency to “close” its properties tab (3)
Step 5
: To delete a frequency, tap the “-” symbol on the right of that frequency (4)
Step 6
: To add a new frequency, tap the “+” symbol at the bottom right beneath all frequencies (5)
